Flips movie box over to check rating…

Thanks I feel called out…

…

…

But Why?

Its a swing. For segs.

You can just make that unnecessary Windows additions. No one asked Microsoft to force copilot or recall or ads or… On to our systems.

The stoolie

Give me your tired, your poor, Your huddled masses yearning to breathe free, The wretched refuse of your teeming shore. Send these, the homeless, tempest-tossed to me, I lift my lamp beside the golden door!

Holy fuck we have strayed far from our foundations.

Right the jumpers would be cable select, master , slave generally. You could use master and slave or cs but shouldn’t together. Not that you can’t but screwing up your jumpers was the easy way to be pulling you hair out for failure to boot to the right drive or failure to id in the right order.

Tuning forks!!! The Zenith clicker The buttons would work strikers that would hit tuned rods. A different one doing a different function.

I don’t know this smells of some pencil Pusher looking at an engineer going “can you bring the cost of that rubber o-ring down 13 cents”… “I know you were looking for a specific type of seal but I got this huge assortment pack right here from my local temu…”

You forgot the Catholic church. But that was for different reasons…

Brain worms.

You mean tax deductions… More lucrative than just biting the loss.

Bet it has a grave yard on property. If your lonely you can dig up some friends.

Freeways/expressways around me are 45 mph minimum. They are normally mounted below the limit sign.

https://www.twincities.com/2015/05/20/more-than-700-miles-of-interstates-in-wisconsin-to-be-70-mph/

But I have seen small tack on signs that are the same in most regards.

https://commons.m.wikimedia.org/wiki/File:SPEED_LIMIT_75mph_MINIMUM_SPEED_50mph_NO_TOLERANCE.png

Just need someone to look behind the 1/8 of a cup of juice in the gallon bottle in the fridge…

cupcake if you think that’s how I’m loading that into my truck you’re the idiot

Did you know there’s actually space between the wheel tubs in the bed of that truck to set those boards down flat. And if your object is still a little wider than that you stack a couple of pallets underneath it to build up to level with the wheel tubs and then load it on top of those still within the bed rails and sides and wouldn’t necessitate having to try and do a side load like this. where your loading over the side you use a sling and don’t just use boards like a fucking idiot.

That’s an example of an idiot. And not how you load that.

Actually yes my ranger fits just fine in some of the tightest of places. Never had a problem fitting into compact car spots with no over hang. With a full size 8 foot bed no less.

My pickup can fit that with a forklift in seconds without hand loading… Can your van…?