I’m going to lose that dongle. You say further down that I can just leave them connected, but I use my headphones with more than my phone (laptop, desktop), and those other devices have a headphone jack. Leaving it plugged in to my phone sucks too, for obvious reasons.
I don’t care about water ingress. I’m happy to give up water resistance and have a slightly thicker phone if it means I get a headphone jack, bonus points if it’s easier to open the phone for repairs.
USB-C to headphone jack dongles suck. You lose them easily, you can’t charge your phone if they’re connected and if you disconnect your headphones the device still behaves as if they’re plugged in. It’s so much less convenient and on the other hand there’s just no downside to having a dedicated headphone jack, so I still don’t get why they’re no longer including them.
As well as all your points (which I 100% agree with), my other issue with these dongles is simply that they stick out way more. If I buy a pair of headphones with an angled connector, I can plug them in and wrap the wire a little bit and then when the phone’s in my pocket, the wire takes up basically no space and doesn’t get smushed about by my leg.
With a dongle, I need an extra couple inches of vertical space, and because the wire/connectors are sticking directly out the phone, they get bent all over the place. Absolutely crap design. Yes 90 degree USB-C to headphone jacks exist but they take up way more space than just a headphone jack.
if you disconnect your headphones the device still behaves as if they’re plugged in.
Again, leave the dongle connected to the headphones, not the phone.
It’s so much less convenient
It is less convenient, but I’d argue not by all that much. More importantly it’s not any less convenient for the vast majority who are already only using Bluetooth.
there’s just no downside to having a dedicated headphone jack
It’s an additional, and to most people superfluous, point for water ingress. Water damage is the most common type of damage in phones.
It takes up space which could be utilised otherwise, like with a slightly larger battery or larger speakers or camera modules.
It’s an additional part which needs to be manufactured, stocked, installed and purchased. Extra cost which only benefits a few. This is especially important to Fairphone in particular because they don’t use off-the-shelf components and promise to supply replacement parts pretty much indefinitely. I.e. Fairphone would have to design a custom module and then have that module in stock and manufactured specifically for them for the lifetime of each of their devices. That’s not a trivial expense.
Quickly checking if you’re an actual human or just a bot I came across this comment of yours:
I have blocked 264 users, 9 communities and 4 instances and it’s made Lemmy much better for me toxicity wise. Whenever a debate gets toxic or someone starts just insulting or discussing in bad faith or I just get a bad vibe from them - I block.
So now you still do the exact same things but with a little dongle, right?
I’m going to lose that dongle. You say further down that I can just leave them connected, but I use my headphones with more than my phone (laptop, desktop), and those other devices have a headphone jack. Leaving it plugged in to my phone sucks too, for obvious reasons.
I don’t care about water ingress. I’m happy to give up water resistance and have a slightly thicker phone if it means I get a headphone jack, bonus points if it’s easier to open the phone for repairs.
USB-C to headphone jack dongles suck. You lose them easily, you can’t charge your phone if they’re connected and if you disconnect your headphones the device still behaves as if they’re plugged in. It’s so much less convenient and on the other hand there’s just no downside to having a dedicated headphone jack, so I still don’t get why they’re no longer including them.
As well as all your points (which I 100% agree with), my other issue with these dongles is simply that they stick out way more. If I buy a pair of headphones with an angled connector, I can plug them in and wrap the wire a little bit and then when the phone’s in my pocket, the wire takes up basically no space and doesn’t get smushed about by my leg.
With a dongle, I need an extra couple inches of vertical space, and because the wire/connectors are sticking directly out the phone, they get bent all over the place. Absolutely crap design. Yes 90 degree USB-C to headphone jacks exist but they take up way more space than just a headphone jack.
Just leave them connected to the headphones.
Dongles with an additional usb port exist.
Again, leave the dongle connected to the headphones, not the phone.
It is less convenient, but I’d argue not by all that much. More importantly it’s not any less convenient for the vast majority who are already only using Bluetooth.
It’s an additional, and to most people superfluous, point for water ingress. Water damage is the most common type of damage in phones.
It takes up space which could be utilised otherwise, like with a slightly larger battery or larger speakers or camera modules.
It’s an additional part which needs to be manufactured, stocked, installed and purchased. Extra cost which only benefits a few. This is especially important to Fairphone in particular because they don’t use off-the-shelf components and promise to supply replacement parts pretty much indefinitely. I.e. Fairphone would have to design a custom module and then have that module in stock and manufactured specifically for them for the lifetime of each of their devices. That’s not a trivial expense.
Yup. If anything, they should add a second USB-C connector. Much more versatile and you can still charge your phone if one of them dies.
These flaky, but simultaneously bulky headphone connectors need to die. They’re inferior in pretty much every way imaginable.
Every day the bait gets lower and lower effort
Quickly checking if you’re an actual human or just a bot I came across this comment of yours:
Guess I’ll take your advice then.