Hi all, I’m trying to have my rpi5 running raspberry OS communicate with the Internet only through the tun0 interface (vpn). For this I wanted to create a ufw ruleset. Unfortunately, I’ve hit a roadblock and I can’t figure out where I’m going wrong.
Can you help me discover why this ruleset doesn’t allow Internet communication over tun0? When I disable ufw I can access the Internet.
The VPN connection is already established, so it should keep working, right?
I hope you can help me out!
This is the script with the ruleset: sudo ufw reset
Set default policies
sudo ufw default deny incoming
sudo ufw default deny outgoing
Allow SSH access
sudo ufw allow ssh
Allow local network traffic
sudo ufw allow from 192.168.0.0/16
sudo ufw allow out to 192.168.0.0/16
Allow traffic through VPN tunnel
sudo ufw allow in on tun0
sudo ufw allow out on tun0
Add routing between interfaces (I read its necessary, not sure why?)
sudo ufw route allow in on tun0 out on wlan0
sudo ufw route allow in on wlan0 out on tun0
sudo ufw enable
Interesting, but by the time I apply the rules the VPN connection has already been established. Wouldn’t that remove the necessity for the last line?
Just to be clear this is a killswitch, that’s what you want right? So that it’s only possible to connect through the VPN (tun0). And if the VPN goes down your internet gets “killed” so you don’t leak your IP.
In that case you want to start ufw when you system starts, so you would need to whitelist your VPN but if your VPN is already connected it should work without whitelisting the IP I guess but never tried it since that’s not recommended.
Understood, yes it’s a kill switch. I’ll test your set of rules in a bit and let you know!